RTX 8930 Wireless Dect Headset
איבערVIEW
This manual explains how to operate the RTX SME VoIP DECT Headset (RTX8930) in generic mode, including power on/off, registration, basic call handling, volume control, and microphone muting.
ספּעסאַפאַקיישאַנז
- מאָדעל: RTX8930 headset
- באַנד קאָנטראָל: Six volume steps (beeps indicate adjustments and limits)
- LED behavior (power/registration status): Blue LED blinks fast during initial signal detection/registration mode; after subscription it blinks with a 2-second interval
- Power-off key combination: Long-press AUX + VOL+ + VOL- for five seconds
Quick Setup & Use
- באַשטימען אויף: דרוק די AUX key. Wait for the blue LED to blink fast until a signal is detected; once subscribed, the voice prompt “Headset subscribed” plays and the blue LED changes to a 2-second interval.
- Initial registration: For first-time setup, switch the headset on; it enters registration mode automatically (blue LED blinking fast).
- Subsequent (re-)registration: דריקן און האַלטן HOOK OFF צוזאַמען מיט VOL+ און וואָל- until the blue LED starts blinking fast. (Note: the blue LED will not enter registration mode if the unit is cradled and charging.)
- ענטפֿערן אַ רופן: דרוק HOOK OFF.
- סוף אַ רוף: דרוק HOOK OFF ווידער.
- Adjust volume during a call: דרוק VOL+ צו פאַרגרעסערן און וואָל- צו פאַרמינערן.
- שטום / ונמוט מיקראָפאָן: דרוק שטום to toggle mute on and off.Headset Operations Manual
וועגן דעם דאָקומענט
This document describes the features and functionalities available in the RTX SME VoIP DECT Headset. We describe how to operate the headset without going into details about its mechanical features. The reference for features and operation in this manual is RTX generic mode.
וילעםדער פירער איז בדעה פֿאַר וואָכעדיק ניצערס און סיסטעם אַדמיניסטראַטאָרס.
אַבריווייישאַנזפֿאַר די ציל פון דעם דאָקומענט, די פאלגענדע אַבריווייישאַנז האַלטן:
- דעקט: דיגיטאַל ענכאַנסט קאָרדלעסס טעלעקאָממוניקאַטיאָנס
- IPEI: אינטערנאַציאָנאַלע פּאָרטאַבלע עקוויפּמענט אידענטיטעט
- מעק: מעדיע אַקסעס קאָנטראָל
- פּבקס: פּריוואַט בראַנטש עקסטשאַנגע
רעפערענצן / פֿאַרבונדענע דאָקומענטן
- [1]: How_To_Deploy_SME_Network_V1.3
- [2]: SME VoIP System Guide, Version 2.5
דאָקומענט געשיכטע
| רעוויזיע | מחבר | אַרויסגעבן טאָג | באַמערקונגען |
|---|---|---|---|
| 0.1 | TMS | 26-יולי-2016 | ערשט ווערסיע. |
טריידמאַרק
| קליענט נאמען | RTX | ווילדעיקס | SNOM | Strongbyte |
|---|---|---|---|---|
| מאָדעל נומ. | RTX8930headset | WAIR-Headset | A190 | VCV2840 headset |
| HVIN | 8930וו10 | WAIRV10 | 190וו10 | 2840וו10 |
| טריידמאַרק |
יקערדיק אָפּעראַציע
This section describes how to switch on and off the RTX8930 headset and how to register the unit on an RTX 8660 SME VoIP system.
How to Switch the Headset On/Off:
באַשטימען אַוועק די כעדסעטTo switch the headset off, long-press the AUX שליסל צוזאַמען מיט די VOL+ און וואָל- keys (press and hold the three keys for five seconds). The blue LED will give a short blink before switching off.
Registration Initial Registration
סאַבסאַקוואַנט רעדזשיסטריישאַנזIf the RTX8930 headset has already been registered on the same or another base system and needs to be re-registered, the required action is to press and hold the HOOK OFF שליסל צוזאַמען מיט די VOL+ און וואָל- keys until the blue LED starts blinking fast.
נאטיץ: The blue LED will not start blinking in registration mode if the unit is cradled and charging. Please check the additional document via [2] for more information about terminal registration on a base system.
רופט אָפּעראַטיאָנס
- ינקאַמינג רופן As the headset receives an incoming call, a ringtone will be played back
- ענטפֿערן אַ ינקאָמינג רופן צו ענטפֿערן אַ ינקאַמינג רופן, דריקן די HOOK OFF שליסל
- אָפּוואַרפן אַ ינקאַמינג רופן It is not currently possible to reject an incoming call
- ענדיקן אַ רוף To end an ongoing call, press the HOOK OFF שליסל
- באַנד און מוטינג It is possible to adjust the earpiece volume up or down during calls by pressing the VOL+ און וואָל- keys, respectively. There are six volume steps. A beep is played back to indicate that the volume is adjusted. A higher frequency beep is played back when the volume cannot be adjusted further up or down.
- מוטיקן די מיקראָפאָן It is possible to mute the microphone during calls by pressing the שטום key. The microphone is unmuted by pressing the שטום key again. A voice prompt announcing “Mute on” is played back when mute is activated. A voice prompt announcing “Mute off” is played back when mute is deactivated.
טראָובלעשאָאָטינג
- Headset doesn’t enter registration mode when re-registering: If you are cradled and charging, the blue LED will not start blinking fast in registration mode. Remove it from the cradle/charging and try again.
- No confirmation after switching on: נאָך דרינגלעך AUX, the blue LED should blink fast until a signal is detected. Once the headset locks onto a base, the voice prompt “Headset subscribed” should play and the LED should switch to blinking with a 2-second interval.
- Volume can’t be increased/decreased: The headset provides higher frequency beeps when the volume cannot be adjusted further up or down.
דאָקומענטן / רעסאָורסעס
 | 8930 Wireless Dect Headset |
רעפערענצן
- באַניצער מאַנואַלmanual.tools