קאָמפּלעמענט שופלאָד אינסטרוקציעס: ייקיאַ באַניצער גייד

Disassembling the IKEA Komplement drawer can be difficult because part 110519 is a plastic expansion pin designed for a permanent friction fit. The official manual does not provide specific disassembly instructions, but you can follow these steps to reverse the process:

• Removing Part 110519: Since this pin is hammered in (as shown on page 8), it does not have a screw head. To remove it, you typically need to gently pry the back panel away from the side panels using a flat-head screwdriver or a putty knife. Alternatively, if the head is accessible, you can try to grip it with pliers and pull it straight out. Be careful not to damage the particle board.
• Unlocking Cam Locks: Locate the circular cam locks (parts 119030, 120076, 117434, or 131177) on the inside of the drawer sides. Use a screwdriver to turn them counter-clockwise (usually 180 degrees) until they release the connecting bolts (part 118331).
• Removing the Drawer from Slides: If the drawer is still in the wardrobe, refer to page 12. You must rotate the locking levers (part 110670) underneath the drawer to release it from the sliding rails.

Note: Because part 110519 is plastic and ribbed, it may deform during removal and might need to be replaced if you intend to reassemble the drawer later.