Dickson WiZARD2 Replaceable Sensor Logger

ספּעסאַפאַקיישאַנז

וויכטיק אָנזאָג
Please follow the steps below before using your chart recorder for the first time.

Set Chart

1. דרוק MENU צוויי מאָל.
2. Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
3. דרוק MENU צו ראַטעווען.
4. Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
5. דרוק MENU צו ראַטעווען.

שטעלן צייט

1. דרוק MENU.
2. ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
3. דרוק MENU צו ראַטעווען.
4. Press HOME. Pens will move onto the chart to begin recording.

אָפּעראַציע

צו אָנהייבן אָפּעראַציע

1. אַראָפּנעמען דעם פּראַטעקטיוון פעדער דעקל.
2. Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
3. Insert Batteries (4 C type) and plug into AC adapter.
4. Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
5. Press the power button and follow the display prompts to configure. באַמערקונג: Unit may power on automatically when AC and battery power are applied.

FAQ

What should I do if the unit does not power on?\

Ensure that both the AC adapter is plugged in and the batteries are correctly installed.

דאָקומענטן / רעסאָורסעס

Dickson WiZARD2 Replaceable Sensor Logger [pdfבאַניצער גייד WiZARD2 Replaceable Sensor Logger, WiZARD2, Replaceable Sensor Logger, Sensor Logger, Logger

רעפערענצן

• באַניצער מאַנואַל