Green Cell PowerCore UPS 1500VA 1000W User Manual

1. הקדמה און איבערview

The Green Cell PowerCore UPS (Uninterruptible Power Supply) is designed to provide reliable backup power and protect your electronic devices from power outages, voltage fluctuations, and surges. This model, with a capacity of 1500VA/1000W, features a pure sine wave output, an intuitive LCD display, and requires an external 12V DC battery for operation. It is ideal for home networks, office equipment, security systems, and sensitive electronics requiring stable power.

2. זיכערקייַט אינסטרוקציעס

Please read and follow these safety instructions carefully before installing or operating the UPS. Failure to do so may result in electric shock, fire, or serious injury.

• External Battery Requirement: This UPS requires an external 12V DC battery (not included) to function. Do not attempt to operate the unit without a properly connected external battery.
• קוואַלאַפייד פּערסאַנעל: The UPS contains hazardous voltages. Repairs should only be performed by authorized service personnel. Any attempt to open or repair the unit by an unqualified user could be dangerous.
• ווענטילאַטיאָן: Ensure adequate ventilation around the UPS. Do not block ventilation openings. Maintain a minimum clearance of 10 cm (4 inches) on all sides.
• סוויווע: Install the UPS in a clean, dry, and temperature-controlled indoor environment. Avoid direct sunlight, heat sources, and areas with excessive dust or humidity.
• פליסיק קאָנטאַקט: Do not expose the UPS to rain, water, or any other liquids. Do not place containers with liquids on or near the unit.
• גראָונדינג: Always connect the UPS to a grounded power outlet.
• אָווערלאָאַד: Do not overload the UPS. Ensure the total power consumption of connected devices does not exceed the UPS's rated capacity (1000W).
• נויטפאַל דיסקאַנעקט: In an emergency, disconnect the UPS from the mains power supply and disconnect the external battery immediately.

3. פּראָדוקט איבערview

Familiarize yourself with the components of your Green Cell PowerCore UPS.

פראָנט פּאַנעל

Figure 3.1: Front Panel with LCD Display

The front panel features an intuitive LCD display that provides real-time information on the UPS status, including input/output voltage, load level, and battery capacity. It also includes a power button and a mute button for alarms.

דערציען פּאַנעל

Figure 3.2: Rear Panel Connectors

די הינטערשטע פּאַנעל גיט אַלע נייטיקע פֿאַרבינדונג פונקטן:

• AC אַרייַנשרייַב: For connecting the UPS to the mains power supply.
• Schuko Outlets (2x): For connecting your devices to be protected.
• DC Battery Terminals (+/-): For connecting the external 12V DC battery.
• Charging Current Switch (L/M/H): Allows adjustment of the battery charging current.
• קרייַז צוימען: גיט איבערלאַסט שוץ.
• קאָאָלינג פאַן: זיכערט געהעריקע היץ דיסיפּיישאַן.

קאָמפּאָנענט דיאַגראַמע

Figure 3.3: Labeled Components (1. Charger, 2. Display, 3. Audible Alarm Switch, 4. Sockets, 5. Removable Fuse, 6. DC Cables)

4. סעטאַפּ

Follow these steps to set up your Green Cell PowerCore UPS.

1. אויספּאַקן די UPS: נעמט פֿאָרזיכטיק אַרויס דעם UPS פֿון זײַן פּאַקעט. קאָנטראָלירט צי עס זענען פֿאַראַן שאָדנס.
2. אָרט: Place the UPS on a stable, flat surface in a well-ventilated area, away from direct sunlight, heat, and moisture. Ensure sufficient clearance for airflow.
3. Connect External Battery:
   

   Figure 4.1: UPS with External Battery Connection

   Connect a 12V DC external battery (AGM type recommended) to the DC battery terminals on the rear panel. Ensure correct polarity: connect the red cable to the positive (+) terminal and the black cable to the negative (-) terminal. This connection is mandatory for the UPS to operate.

4. Set Charging Current: Adjust the 'CHARGING CURRENT' switch on the rear panel to match the capacity of your external battery. Refer to your battery's specifications for the appropriate charging current (Low/Medium/High).
5. Connect to Mains Power: Plug the UPS's AC input cable into a grounded wall outlet.
6. פאַרבינדן דיווייסאַז: Plug your electronic devices (e.g., computer, monitor, router) into the Schuko output sockets on the rear panel of the UPS. Do not exceed the UPS's maximum load capacity of 1000W.

5. אַפּערייטינג ינסטרוקטיאָנס

מאַכט אויף / אַוועק

• צו מאַכט אויף: Press and hold the power button on the front panel for approximately 3 seconds until the LCD display illuminates and the UPS emits a short beep.
• צו מאַכט אַוועק: Press and hold the power button for approximately 3 seconds until the LCD display turns off.

פֿאַרשטיין די לקד ווייַז

The LCD display provides critical information about the UPS status:

• אַרייַנשרייַב וואָלtage: ווייזט דעם איצטיקן באַנדtage from the mains power supply.
• רעזולטאַט חלקtage: דיספּלייז די וואָלtage צוגעשטעלט דורך די UPS צו פארבונדענע דעווייסעס.
• לאָדן מדרגה: ינדיקייץ די פּראָצענטtage פון די UPS'ס קאַפּאַציטעט וואָס ווערט גענוצט דורך פֿאַרבונדענע דעוויסעס.
• באַטאַרייע קאַפּאַציטעט: Shows the charge level of the external battery.
• סטאַטוס ינדיקאַטאָרס: Icons may light up to indicate utility mode, battery mode, overload, or other warnings.

שטום פֿונקציע

בעת אַ מאַכט אָtage or certain alarm conditions, the UPS may emit an audible alarm. Press the mute button on the front panel to silence the alarm temporarily.

ריין סינוס וואַווע רעזולטאַט

The Green Cell PowerCore UPS provides a pure sine wave output, which is identical to the power supplied by the utility grid. This ensures compatibility and safe operation for sensitive electronics such as PCs, servers, refrigerators, and heating systems, preventing damage or malfunctions caused by unstable voltage.

6. וישאַלט

Proper maintenance ensures the longevity and reliable performance of your UPS.

• באַטערי זאָרגן: Since an external battery is used, regularly check its connections for corrosion and ensure they are secure. Follow the battery manufacturer's guidelines for maintenance and replacement.
• רייניקונג: Keep the UPS clean and free of dust. Use a soft, dry cloth to wipe the exterior. Do not use liquid cleaners or solvents. Ensure ventilation openings are clear.
• רעגולער טשעקס: Periodically test the UPS by disconnecting it from the mains power to ensure it switches to battery mode correctly and provides backup power.
• Fuse Replacement: If the UPS has a user-serviceable fuse (refer to Figure 3.3, item 5), ensure to replace it with a fuse of the exact same type and rating if it blows. Always disconnect the UPS from all power sources before attempting fuse replacement.

7. טראָובלעשאָאָטינג

If you encounter issues with your UPS, refer to the following common problems and solutions.

If the problem persists after attempting these solutions, please contact Green Cell customer support for further assistance.

8. ספּעסאַפאַקיישאַנז

Detailed technical specifications for the Green Cell PowerCore UPS 1500VA 1000W.

9. וואָראַנטי און שטיצן

For warranty information, technical support, or service inquiries, please refer to the warranty card included with your product or visit the official Green Cell webזייטל. האַלט אייער קויף קוויטל ווי אַ באַווייַז פון קויפן.