1. הקדמה
This manual provides comprehensive instructions for the installation, operation, and maintenance of your 2GIG Z-Wave 700 Programmable Thermostat, Model 2GIG-STZ-1. This device allows for remote control of your heating and air conditioning systems via a Z-Wave network, in addition to direct control from the thermostat unit.
The 2GIG-STZ-1 thermostat is compatible with most modern HVAC systems, including standard Gas/Electric (2-stagE באַהיצונג, 2-stage cooling) and Heat Pump systems (3-stagE באַהיצונג, 2-stage cooling), with support for humidifiers and dehumidifiers.
פיגורע 1: פראָנט view of the 2GIG Z-Wave 700 Programmable Thermostat, displaying current temperature, fan status, and time.
שליסל פֿעיִקייטן:
- Z-Wave קאָנטראָל: Seamless integration with smart home systems for remote access.
- ווערסאַטאַל קאַמפּאַטאַבילאַטי: Supports standard gas/electric, heat pump, and humidifier/dehumidifier systems.
- גרינג ינסטאַלירונג: Designed for straightforward replacement of existing thermostats.
- צווייענדיק מאַכט מקור: Operates on 4 AA batteries or 24VAC power from your HVAC system.
- קלאָר ווייַז: Large, easy-to-read LCD for temperature control and monitoring.
2. זיכערקייַט אינפֿאָרמאַציע
Please read all instructions carefully before installing or operating this thermostat. Failure to follow these instructions could result in property damage, injury, or death.
- עלעקטריקאַל זיכערקייַט: Always turn off power to the HVAC system at the circuit breaker before installing or servicing the thermostat.
- Voltage קאַמפּאַטאַבילאַטי: This thermostat is designed for 24VAC systems only. It is NOT compatible with 120/240 VAC systems.
- ייַנמאָנטירונג פון באַטאַרייע: If powering the thermostat via 24VAC, do not install AA batteries. Batteries are for backup power only if 24VAC is not available or desired.
- פאַכמאַן ינסטאַלירונג: אויב איר זענט נישט זיכער וועגן קיין טייל פון די אינסטאַלאַציע פּראָצעס, קאָנסולטירט אַ קוואַליפֿיצירטן HVAC טעכניקער.
3. פּעקל אינהאַלט
באַשטעטיקן אַז אַלע זאכן זענען פאַראַן אין פּעקל:
- 2GIG Z-Wave 700 Programmable Thermostat (Model 2GIG-STZ-1)
- 4 רענטגענ אַאַ באַטעריז
- מאָנטירונג האַרדווער (שרויף און וואַנט אַנקערס)
- ינסטאַללאַטיאָן מאַנואַל (דעם דאָקומענט)
- שנעל אָנהייב גייד
4. ינסטאַלירונג
4.1. פּריפּערינג פֿאַר ייַנמאָנטירונג
- Turn off power to your heating and cooling system at the main circuit breaker.
- Remove your old thermostat's cover. Take a picture of the wiring connections for reference.
- Label each wire with the corresponding terminal letter from your old thermostat.
- Disconnect the wires and remove the old thermostat's mounting plate.
4.2. Mounting the Back Panel
The back panel of the 2GIG-STZ-1 thermostat serves as the mounting base and wiring terminal.
- Feed the wire cable from the wall through the access hole in the new mounting plate.
- Use the provided wall anchors and two Phillips screws to secure the back panel to the wall.
- Ensure the back panel is level for proper aesthetic alignment.
Figure 2: Illustration of mounting the back panel, showing wire access and screw locations.
4.3. וויירינג דעם טערמאָסטאַט
Connect the labeled wires to the corresponding terminals on the thermostat's back panel. Refer to your old thermostat's wiring diagram and the labels you made. The 2GIG-STZ-1 supports the following configurations:
- Standard Gas/Electric HVAC: אַרויף צו 2 סעקונדעסtagE באַהיצונג, 2-stagE קאָאָלינג.
- Heat Pump HVAC: אַרויף צו 3 סעקונדעסtagE באַהיצונג, 2-stagE קאָאָלינג.
- Humidifier/Dehumidifier Support: Dedicated terminals available.
For 24VAC power, ensure both "R" and "C" wires are connected. If a "C" wire is not available, the thermostat can be powered by 4 AA batteries, but it will not repeat Z-Wave signals in your network.
4.4. אַטאַטשינג די פראָנט פּאַנעל
Once wiring is complete, attach the thermostat's front panel to the mounted back panel.
- Align the front panel with the back panel.
- Gently press the front panel onto the back panel until it snaps securely into place around all edges.
Figure 3: Illustration of attaching the front panel to the back panel, showing the snap-together mechanism.
After the front panel is attached, restore power to your HVAC system at the circuit breaker.
5. אַפּערייטינג ינסטרוקטיאָנס
5.1. אנשטעלן דעם טערמאסטאט
The thermostat can be powered by 24VAC from your HVAC system (if "R" and "C" wires are connected) or by four (4) AA batteries. If 24VAC is supplied, batteries are not required for operation but can serve as a backup. If only battery-powered, the thermostat will not function as a Z-Wave repeater.
5.2. גרונטלעכע קאנטראלן
The thermostat features a clear LCD display and intuitive buttons for control:
- FAN קנעפּל: Cycles through fan modes (Auto, On).
- מאָדע קנעפּל: Cycles through system modes (Heat, Cool, Auto, Off, Em Heat).
- אַרויף / אַראָפּ אַראָוז: Adjusts the temperature setpoint.
5.3. אַדזשאַסטינג טעמפּעראַטור
דרוק די Up or אַראָפּ arrow buttons to increase or decrease the desired temperature setpoint. The display will show the new setpoint temporarily.
5.4. Z-Wave Network Integration
To integrate the thermostat into your Z-Wave network, refer to your Z-Wave hub's instructions for adding new devices. The 2GIG-STZ-1 is a Z-Wave 700 series device, offering enhanced range and battery life. Once paired, you can control the thermostat remotely via your Z-Wave smart device or hub interface.
באַמערקונג: For optimal Z-Wave performance and to function as a Z-Wave repeater, the thermostat should be powered by 24VAC.
6. וישאַלט
6.1. רייניקונג פון דעם טערמאָסטאַט
צו רייניקן דעם טערמאָסטאַט, ווישט אָפּ די אויסערלעכע זייט מיט אַ ווייכן, טרוקענעם שטאָף.amp cloth. Do not use abrasive cleaners, solvents, or spray cleaners directly onto the thermostat, as this may damage the unit or its electronic components.
6.2. באַטערי פאַרבייַט
If your thermostat is battery-powered, replace the four (4) AA batteries when the low battery indicator appears on the display. Ensure to use fresh, high-quality alkaline batteries. If the thermostat is 24VAC powered, battery replacement is not typically required for operation, but batteries can be installed for backup power.
- Carefully remove the front panel of the thermostat from the back panel.
- אַראָפּנעמען די אַלט אַאַ באַטעריז.
- Insert four new AA batteries, ensuring correct polarity (+/-).
- Reattach the front panel to the back panel until it snaps securely.
7. טראָובלעשאָאָטינג
If you encounter issues with your 2GIG-STZ-1 thermostat, refer to the following common problems and solutions:
| פּראָבלעם | מעגלעך סיבה | לייזונג |
|---|---|---|
| Thermostat has no power/blank display. | No 24VAC power; dead batteries; incorrect wiring. | Check circuit breaker for HVAC system. Replace AA batteries if battery-powered. Verify "R" and "C" wire connections. |
| די HVAC סיסטעם רעאַגירט נישט אויף די טערמאָסטאַט. | Incorrect wiring; system mode set to "Off"; Z-Wave communication issue. | Double-check wiring. Ensure system mode is set to "Heat", "Cool", or "Auto". Re-pair with Z-Wave network if controlling remotely. |
| Temperature swing is too wide. | Thermostat differential settings. | Consult the advanced settings menu (if available) or your Z-Wave controller for options to adjust temperature differential. This setting controls how far the temperature deviates from the setpoint before the system activates. |
| קען נישט קאנעקטן צום Z-Wave נעטווארק. | Thermostat too far from hub; interference; incorrect pairing procedure. | Ensure thermostat is within range of the Z-Wave hub or a repeater. Follow Z-Wave hub's specific instructions for inclusion/exclusion. Ensure thermostat is 24VAC powered to act as a repeater. |
8. ספּעסאַפאַקיישאַנז
| שטריך | דעטאַל |
|---|---|
| מאָדעל נומער | 2GIG-STZ-1 (also known as 2GIG-STZ1-345) |
| קאַמפּאַטאַבילאַטי | 24VAC 3H/2C non-heat pump/heat pump systems with humidifier/dehumidifier support. Not compatible with 120/240 VAC systems. |
| Room Temperature Measurement Scale | Fahrenheit / Celsius (user selectable) |
| צימער טעמפּעראַטור ראַנגע | 32 צו 122 דיגריז F (0 צו 50 דיגריז C) |
| טעמפּעראַטור אַקקוראַסי | +/- 1 degrees F (0.5 degrees C) |
| Heat Set Point Range | 32 - 90 degrees F (0 - 32 degrees C) |
| Cool Set Point Range | 61 - 122 degrees F (16 - 50 degrees C) |
| באַשטעטיקן האַכלאָטע | 1 דיגריז F (0.5 דיגריז C) |
| פאָכער קאָנטראָל | אַוטאָ/אויף |
| מאַכט צושטעלן | AC: 18-26VAC 60Hz (R and C); 4x AA size battery (6VDC) |
| אַפּערייטינג טעמפּעראַטור ראַנגע | 32 צו 122 דיגריז F (0 צו 50 דיגריז C) |
| אַפּערייטינג הומידיטי | 10-90 percent Non-Condensing |
| דימענשאַנז (H X W X D) | 5.75 X 4.5 X 1 אין (14.6 X 11.4 X 2.5 סענטימעטער) |
| וואָג | 1.06 לבס (0.48 קג) |
| קאַנעקטיוויטי | Z-Wave (700 סעריע) |
| ווייַז טיפּ | לקד מיט באַקלייט |
9. וואָראַנטי אינפֿאָרמאַציע
The 2GIG Z-Wave 700 Programmable Thermostat (Model 2GIG-STZ-1) comes with a לימיטעד 1-יאָר וואָראַנטי from the manufacturer. Please retain your proof of purchase for warranty claims. For specific terms and conditions, refer to the warranty documentation included with your product or contact 2GIG customer support.
10. קונה שטיצן
For further assistance, technical support, or warranty inquiries, please contact 2GIG customer support. You may also refer to the support resources provided by your Z-Wave hub manufacturer for integration-specific questions.
באַמערקונג: Manufacturer support policies may vary. Access to detailed manuals or direct support might be restricted to authorized dealers or installers in some cases.
