Samson CR-277-HH Handheld Wireless System User Manual

הקדמה

Thank you for choosing the Samson CR-277-HH Handheld Wireless System. This system is designed to provide reliable and high-quality audio transmission for various applications, including live performances, presentations, and public speaking. It features a dual UHF wireless receiver and two dynamic handheld microphone transmitters, ensuring clear and consistent sound.

This manual provides detailed instructions for setting up, operating, maintaining, and troubleshooting your CR-277-HH system. Please read it thoroughly before use to ensure optimal performance and longevity of your equipment.

Figure 1: The Samson CR-277-HH Handheld Wireless System, showing the CR277 dual UHF receiver and two HT7 handheld microphone transmitters.

סעטאַפּ גייד

אַנפּאַקקינג און דורכקוק

Carefully unpack all components and inspect them for any signs of damage. If any item is missing or damaged, contact your dealer immediately.

דער פּעקל זאָל אַרייַננעמען:

• CR277 Half-Rack Dual UHF Wireless Receiver
• Two HT7 Dynamic Handheld Microphone Transmitters
• מאַכט אַדאַפּטער
• Audio Cables (e.g., 1/4-inch to 1/4-inch)
• 9-volt Batteries (for transmitters)

Figure 2: Included components of the Samson CR-277-HH system, showing the receiver, two microphones, power adapter, and connecting cables.

ופנעמער פּלייסמאַנט

Place the CR277 receiver on a stable, flat surface, away from potential sources of interference such as computers, large metal objects, or other wireless devices. Ensure adequate ventilation around the unit.

קאַנעקטינג די ופנעמער

1. Connect the included power adapter to the DC input on the rear panel of the CR277 receiver and then to a suitable power outlet.
2. Connect the receiver's audio outputs to your mixer, amplifier, or PA system. You can use either the two independent 1/4-inch outputs (one for each channel) or the single 1/4-inch mix output.
3. Extend the tuned molded antennas for optimal signal reception.

Battery Installation (HT7 Transmitters)

Each HT7 handheld microphone transmitter requires one 9-volt battery for operation. To install the battery:

1. Unscrew the bottom section of the microphone handle.
2. Insert a fresh 9-volt battery, observing the correct polarity (+/-).
3. Screw the bottom section back onto the microphone handle until secure.

Each transmitter is designed to operate for approximately 12 hours on a single 9-volt battery.

אַפּערייטינג ינסטראַקשאַנז

מאַכט אויף / אַוועק

1. ופנעמער: Press the POWER button on the front panel of the CR277 receiver to turn it on. The power indicator will illuminate.
2. טראַנסמיטער: Slide the ON/OFF switch on each HT7 microphone transmitter to the 'ON' position. The power/battery indicator on the transmitter will light up.

אַדזשאַסטינג לעוועלס

The CR277 receiver features independent level controls for each channel (Ch U1 and Ch U2). Adjust these knobs to set the desired output volume for each microphone. Monitor the multi-segment RF level and peak audio indicators to ensure optimal signal strength without clipping.

Figure 3: Front panel of the CR277 receiver, highlighting the independent level controls, RF level, and peak audio indicators for each channel.

ניצן די מיקראָפאָן

Hold the HT7 microphone approximately 2-6 inches from your mouth for best vocal pickup. The Q7 dynamic microphone element is designed for clear and articulate sound reproduction.

קאָנטראָל קאָנטראָל

The CR277 receiver includes squelch control for each channel. This feature helps to eliminate unwanted noise when the transmitter signal is weak or absent. Adjust the squelch knob clockwise to increase the squelch threshold, reducing background noise. Adjust it counter-clockwise to decrease the threshold, allowing weaker signals to pass through.

וישאַלט

רייניקונג

To clean the receiver and microphones, use a soft, dry cloth. For stubborn dirt, a slightly damp cloth can be used, but ensure no moisture enters the internal components. Do not use abrasive cleaners or solvents.

באַטערי פאַרבייַט

Replace the 9-volt batteries in the HT7 transmitters when the power/battery indicator on the microphone begins to dim or when audio quality degrades. Always use fresh, high-quality alkaline batteries for optimal performance and battery life.

סטאָרידזש

When not in use for extended periods, remove the batteries from the transmitters to prevent leakage. Store the system in a cool, dry place, away from direct sunlight and extreme temperatures.

טראָובלעשאָאָטינג

If you encounter issues with your Samson CR-277-HH system, refer to the table below for common problems and their solutions.

טעכניש ספּעסאַפאַקיישאַנז

וואָראַנטי און שטיצן

Samson products are manufactured to the highest standards and are backed by a limited warranty. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Samson webפּלאַץ.

For technical support, service, or replacement parts, please contact your authorized Samson dealer or Samson customer service directly. Keep your purchase receipt as proof of purchase for warranty claims.