Westek TMSW15MI Hardwire Indoor In-Wall 15 Minute Mechanical Countdown Timer

הקדמה

The Westek TMSW15MI is a hardwire indoor in-wall mechanical countdown timer designed to automatically turn off lights and motors after a selected time, up to 15 minutes. This device replaces a standard single-pole, single-throw wall switch, providing convenient timed control for various electrical loads.

בילד: פראָנט view of the Westek TMSW15MI In-Wall Mechanical Countdown Timer, showing the ivory finish and the twist knob for setting the countdown time.

זיכערקייַט אינפֿאָרמאַציע

WARNING: RISK OF ELECTRIC SHOCK. Improper installation can result in serious injury or death. Always consult a qualified electrician if you are unsure about any part of the installation process.

• קער אַוועק מאַכט at the circuit breaker or fuse box before installing or servicing the timer.
• Verify that power is off before proceeding with installation.
• This timer is for דרינענדיק נוצן בלויז.
• נישט איבערשרייטן די מאקסימום עלעקטרישע רייטינגס פון דעם אפאראט.
• זיכער מאַכן אַז אַלע דראָט פֿאַרבינדונגען זענען זיכער און ריכטיק איזאָלירט.
• This device must be installed in accordance with all national and local electrical codes.

פּעקל אינהאַלט

• 1 x Westek TMSW15MI In-Wall Mechanical Countdown Timer
• מאַונטינג סקרוז
• Wire Nuts (typically included, but may vary)
• ינסטראַקשאַנז בלאַט

ספּעסאַפאַקיישאַנז

ייַנמאָנטירונג

Replacing an Existing Wall Switch

1. קער אַוועק מאַכט: Locate the circuit breaker or fuse that controls the switch you are replacing and turn it OFF. Verify the power is off by attempting to operate the switch or using a voltagE tester.
2. Remove wall plate: Unscrew and remove the existing wall plate.
3. אַראָפּנעמען דעם אַלטן סוויטש: Unscrew the old switch from the electrical box and carefully pull it out.
4. Disconnect wires: Note the wiring configuration of the old switch. Typically, there will be two load/line wires connected to the switch and a ground wire. Disconnect these wires.
5. Connect new timer: The Westek TMSW15MI timer has screw terminals. Connect the two load/line wires from the electrical box to the two terminals on the timer. If a ground wire is present in the box, connect it to the green ground screw on the timer (if available) or to the box's ground. Ensure all connections are tight and secure.
6. מאָנטירן טייַמער: Carefully push the wired timer back into the electrical box. Secure it with the provided mounting screws.
7. אינסטאַלירן וואַנט פּלאַטע: Attach the new or existing wall plate over the timer.
8. צוריקשטעלן מאַכט: צינדט צוריק אן די מאַכט ביים קרייז ברעיקער אדער פיוז קעסטל.

וויכטיק: This timer is designed for single-pole applications only. Do not attempt to install it in a 3-way or 4-way switch configuration unless you are certain of the wiring and have consulted a qualified electrician.

אַפּערייטינג ינסטראַקשאַנז

The Westek TMSW15MI mechanical countdown timer is simple to operate:

1. צו אַקטאַווייט די טייַמער: Rotate the knob clockwise to the desired countdown time (up to 15 minutes).
2. The connected device (light, motor, etc.) will turn ON immediately.
3. די טייַמער וועט אָנהייבן קאַונטינג אַראָפּ.
4. Once the set time has elapsed, the timer will automatically turn OFF the connected device by breaking the electrical circuit.
5. To turn the device ON again, simply rotate the knob to the desired time.

וישאַלט

• רייניקונג: צו רייניקן דעם טייַמער, ווישט די ייבערפלאַך מיט אַ ווייכן, דamp שטאָף. ניצט נישט קיין שרײַבנדיקע רייניגערס אדער סאָלווענטן. מאַכט זיכער אַז די מאַכט איז אויסגעלאָשן איידער איר רייניקט.
• No user-serviceable parts: The internal mechanism of the timer contains no user-serviceable parts. Do not attempt to open or repair the unit.

טראָובלעשאָאָטינג

• Timer does not turn ON:
  • קוק אויב דער קרייז ברעיקער איז אן.
  • ענשור אַז אַלע דראָט קאַנעקשאַנז זענען זיכער.
  • Verify the load is within the timer's electrical ratings.
• Timer does not turn OFF:
  • Ensure the knob is set to a specific time and not stuck.
  • The internal mechanism may be faulty. If so, the unit may need replacement.
• Timer makes a ticking sound:
  • This is normal for mechanical timers as the internal gears operate.

וואָראַנטי

This Westek product is covered by a 1-יאָר לימיטעד וואָראַנטי from the date of purchase. This warranty covers defects in materials and workmanship under normal use. It does not cover damage resulting from misuse, abuse, improper installation, or unauthorized repairs. For warranty service, please retain your proof of purchase and contact Westek customer support.

קונה שטיצן

For further assistance, technical support, or warranty inquiries, please visit the official Westek website or contact their customer service department. Refer to the packaging or the Westek webזייטל פֿאַר די מערסט אַקטועלע קאָנטאַקט אינפֿאָרמאַציע.

Westek Official Webפּלאַץ: Visit the Westek Store on Amazon