Samson Concert 277 Dual Handheld True Diversity UHF Wireless System User Manual

1. הקדמה און איבערview

The Samson Concert 277 Dual Handheld Wireless System offers a professional wireless solution for various vocal applications, providing two independent channels for simultaneous operation of two HT7 handheld transmitters. This system is designed for reliable and clear audio reproduction, suitable for multiple vocalists, presenters, or performers.

שליסל פֿעיִקייטן אַרייַננעמען:

• Dual Channel True Diversity UHF Wireless System
• Simultaneous operation of two HT7 wireless transmitters
• Phase-Locked Loop (PLL) circuitry for flawless reception
• Multi-segment RF level and peak audio indicators for each channel
• Squelch control for each channel

2. וואָס איז אין דער קעסטל

ביים אויספּאַקן, קאָנטראָלירט אַז אַלע קאָמפּאָנענטן זענען פאַראַן:

• Samson Concert 277 CR277 True Diversity Half-Rack UHF Receiver
• Two HT7 Handheld Transmitters (Microphones)
• מאַכט אַדאַפּטער
• Audio Cable (1/4-inch to 1/4-inch)
• באַניצער מאַנואַל (דעם דאָקומענט)

Figure 2.1: Contents of the Samson Concert 277 Dual Handheld Wireless System package.

3. סעטאַפּ

3.1 Receiver Placement and Connections

1. אָרט: Position the CR277 receiver in a location free from obstructions and away from other electronic devices that may cause interference. Ensure adequate ventilation.
2. אַנטענאַז: Extend the two antennas on the rear of the receiver fully and position them at a 45-degree angle for optimal signal reception.
3. מאַכט קשר: Connect the supplied power adapter to the DC input on the rear of the receiver and plug it into an AC power outlet.
4. אַודיאָ רעזולטאַט: Connect the receiver's audio outputs to your mixer, amplifier, or PA system.
   • Use the balanced XLR outputs for long cable runs and professional connections.
   • Use the unbalanced 1/4-inch output for shorter cable runs or connections to consumer-level equipment.

3.2 Transmitter (Microphone) Setup

1. ייַנמאָנטירונג פון באַטאַרייע: Unscrew the bottom portion of each HT7 handheld transmitter. Insert a fresh 9V battery, observing the correct polarity (+/-). Securely reattach the bottom portion.
2. מאַכט אויף: Locate the power switch on each HT7 transmitter and slide it to the "ON" position. The LED indicator on the transmitter should illuminate briefly.

4. אַפּערייטינג ינסטרוקטיאָנס

4.1 מאַכט אויף די סיסטעם

1. Ensure the receiver is connected to power and audio outputs.
2. Turn on the CR277 receiver using the power button on the front panel. The power indicator LED will light up.
3. Turn on both HT7 handheld transmitters.

4.2 Channel Synchronization and Volume Control

The Concert 277 system features automatic frequency matching. Once the receiver and transmitters are powered on, they should automatically synchronize to the correct channels (N1 and N2).

• RF Level Indicators: Observe the multi-segment RF level LED meters on the receiver's front panel for each channel (Ch 1 and Ch 2). These indicate the strength of the wireless signal.
• Audio Peak Indicators: The peak audio indicators will light up when the audio signal from the microphone is too strong, potentially causing distortion. Adjust the microphone's gain or your mixer's input level if this occurs.
• באַנד קנעפּלעך: Use the two large rotary volume knobs on the receiver's front panel to adjust the output level for each channel independently. Start with these at a low setting and gradually increase to a comfortable listening level.

פיגורע 4.1: עקסample of the Samson wireless microphone system in use.

4.3 Microphone Usage Tips

• Hold the microphone approximately 2-6 inches from your mouth for optimal vocal pickup.
• Avoid covering the microphone grille with your hand, as this can affect sound quality and cause feedback.
• Be mindful of proximity effect: holding the microphone closer will increase bass response.

5. וישאַלט

• רייניקונג: Use a soft, dry cloth to clean the exterior surfaces of the receiver and transmitters. Do not use abrasive cleaners or solvents. For microphone grilles, a soft brush can be used to remove debris.
• באַטערי פאַרבייַט: Replace the 9V batteries in the HT7 transmitters when the battery indicator on the transmitter or receiver shows low power. Always use fresh, high-quality alkaline batteries. Remove batteries if the system will not be used for an extended period to prevent leakage.
• סטאָרידזש: האַלט די סיסטעם אין אַ קיל, טרוקן אָרט, אַוועק פון דירעקט זונשייַן און עקסטרעמע טעמפּעראַטורן.

6. טראָובלעשאָאָטינג

7. ספּעסאַפאַקיישאַנז

8. וואָראַנטי און שטיצן

Samson products are designed for reliability and performance. For specific warranty information, please refer to the warranty card included with your product or visit the official Samson website. Technical support and service information can also be found on the Samson webפּלאַץ.

פֿאַר ווייַטער הילף, ביטע באַזוכן: www.samsontech.com